ATV 200 - (VI)Replacement of Engine Oil of Rear Driving Gear Case

(VI)Replacement of engine oil of rear driving
gear case.
1.Place the vehicle on the flat ground.
2.Place an oil catcher under the rear driving gear
case.
3.Remove:
.Below cover of gear case.
.oil filling screw plug
.oil draining screw plug
Drain out the engine oil of the rear driving gear
case.
4.Check:
.Sealing washer (oil filling screw plug position)
.Sealing washer (oil draining screw plug
position)
‘If damaged, replace them.
5.Install:
Oil draining screw plug(rear driving gear case)
Torsion of oil draining screw plug:23N.m
6.Oil filling screw plug
Avoid the foreign matter to enter the driving gear
case.
Caution
7.Install:
.Oil filling screw plug(rear draining gear case)
After refilling, check the leakage.
Torsion of oil filling screw plug: 23N.m
Caution
Recommended oil:
SAE80API “GL-4” engine oil of hypoid gear
If needing, you may use SAE80W90 engine
oil of hypoid gear
Periodic replacement:
0.12L
Total capactity:
0.27L
- 43 -