Take off bearing ¢Ûwith usually bearing tool
The reverse step of “bearig and oil sealing re-
placing step”is the mounting step of new bear-
ing and new oil sealing.
Use a pressure tooling ¢Üwhich is match with
outer diameter of bearing race ¢ßand oil
sealing.
Don’t strike the bearing inner race
¢Ý and
roller.
The pressure tooling ¢Ü is only contact with
outer race ¢ß .
(III)Mounting steps:
The reverse steps of “disassembly is the mount-
ing step,but the following points must be paid
attention during the installation: ”
1.Lubricate the bearing¢Ù, oil sealing¢Ú,bush
¢Û and rear arm joint bolt¢Ü.
Lubrication oil is lithium base grease.
2.Mount the real wheel fork assy, rear wheel
fork bushing and rear arm joint bolt.
Caution
Warning
- 111 -
To Next Page
Loading...
