ATV 200 - (VIII)Adjustment of Timing Chain Tension

3.Installation:
Carry out it according to opposite steps of
“Removal”.
(1)Mount:
a.Valve cap (Side of outlet door)
b.Valve cap (Side of inlet door)
Caution
(i)Project of valve cap ¢Ù ¢Úshould be up ¢Û
when mounting.
(ii)Check if O-ring ¢Üis damaged. if any, re-
place it immediately.
Torque of valve cap: 10N.m
(2)Mount:
a.Oil tank(see Installation of oil Tank in sec-
tion )
b.Upper cover of oil tank
c.Seat(See Installation of seat in section2)
(VIII)Adjustment of timing chain tension
The engine has automatic adjusting tensioner
on the timing chain tension.So manual adjust-
ment is unnecessary.
- 60 -