Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2 - Rubber stop
❑ If lid is adjusted correctly, stop buffers must lightly contact body when lid is closed.
❑ Adjusting ⇒ page 60 .
3 - Pop rivet
❑ To remove, drill out rivet head and drive out rivet shaft.
4 - Rear lid lock
❑ To remove, remove combi-bolts and disengage cable.
5 - Nuts
❑ 21 Nm
6 - Cable for emergency release
7 - Striker
❑ Adjusting:
– Tighten combi-bolts ⇒ Item 5 (page 60) by hand (it must still be possible to slide striker).
– Carefully close the rear lid so that it is flush with the side panels.
– Carefully open lid and tighten bolts ⇒ Item 5 (page 60) .
8 - Nuts
❑ 21 Nm
9 - Protective film
❑ Self-adhesive.
❑ Remove protective paper before applying.
10 - Hood hinge
❑ Removing and installing, refer to ⇒ “2.4.3 Rear Lid Hinge“, page 61
2.4.2 Stop Buffer
Removing
– Close the rear lid.
Note
If lid is adjusted correctly, stop buffers must lightly contact body
when lid is closed.
– The replacement buffers are pre-adjusted and are moved out
or in only when needed.
– Check gap dimensions ⇒ page 20 .
Note
To remove stop buffer, drill out rivet head -1-, drive out rivet shaft
and remove buffer.
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
60 Rep. Gr.55 - Hood, Lids
To Next Page
Loading...
