Page | 31 of 105
AVR8414 Operation Manual – Rev O
Date/Time
The Date/Time of the AVR8414 can be configured through the On-Screen Display. From the
Main Menu, access the Configure > Time/Date menu. The user can then toggle through and
set the date, time and UTC Offset. The Date/Time configuration is broken up into three
sections: Manual Date/Time, NTP Date/Time, and UTC Offset.
The user can configure the DVR to display either local or UTC time on the DVR status bar. If
UTC is selected, “UTC” will be shown next to the time.
Manual Date/Time
This option is available for those who are not connected to a network and would still like to
enter the current date/time manually.
NTP Date/Time
The AVR8414 allows the user the option of retrieving the current date/time from an NTP
(Network Time Protocol) Server. The default NTP server used is 129.6.15.30. This address can
be changed in the “NTP Server IP Address” field. NTP will use SNTP (Simple Network Time
Protocol) if SNTP is checked.
Figure 27 – OSD Manual Date/Time
To Next Page
Loading...