Page | 63 of 105
AVR8414 Operation Manual – Rev O
Configuration File
The AVR settings can be loaded from a configuration avr8414*.ini file. In order to provide the
settings, the configuration file must be loaded onto an SD, SSD, or USB storage device and
then uploaded to the unit through the configuration page. This is done by selecting the storage
device and then selecting Upload. Once the settings have been loaded, the AVR will be locked
in the state from the configuration file, which means that the unit will always boot up in that
configuration until such time as the configuration is disabled. The configuration can be
disabled from the Configuration File menu.
In addition to the configuration avr8414*.ini file, the user can export current settings from the
AVR to an avr8414.set file. This avr8414.set file can be used to upload the AVR’s configuration
onto other AVRs. Exporting settings can be done in the Configuration File menu in the “Export
Settings To Configuration File (.set)” section.
Figure 69 - Configuration File Menu
To Next Page
Loading...
Need help?
General