Page | 66 of 105
AVR8414 Operation Manual – Rev O
Information and warning notifications are displayed in a white horizontal bar at the bottom of
the display. The dwell time (how long the notification is displayed) can be set to the system
default or to a value between two and ten seconds.
If Auto Passthrough is set to “Yes”, the video passthrough channel will be set automatically. If
set to “No”, the passthrough channel will be the last operator selected video input. If the last
operator selected video input is not available, passthrough will be disabled.
Auto Passthrough attempts to set passthrough to the first active record channel under these
circumstances:
• A recording is started.
• Playback is stopped.
• A video input is detected or lost.
Figure 72 - Display Configuration Menu
To Next Page
Loading...
Need help?
General