Page | 86 of 105
AVR8414 Operation Manual – Rev O
dimOnDiscreteState=open
#muteOnDiscreteId options are 1, 2, 3 or 0 (disabled), ** defaults to 0
muteOnDiscreteId=0
#muteOnDiscreteState only applicable if muteOnDiscreteId=1 or 2 or 3 options are open or ground
muteOnDiscreteState=ground
#discreteOutSignal option are none, rec-active or bit-failure, ** defaults to none
discreteOutSignal=none
#discreteOutSignalState option are open or closed, ** defaults to open
discreteOutSignalState=closed
[Time]
#ntpEnable options are yes or no, ** defaults to no
ntpEnable=no
#ntpServerIp for example NTP server at NIST, Gaithersburg, Maryland: ntpServerIp=129.6.15.30,
# required if ntpEnable=yes
ntpServerIp=129.6.15.30
#ntpUseSntp options are yes or no, ** defaults to no (SNTP = Simple Network Time Protocol),
#when using SNTP to synchronize with a SNTP broadcast server set ntpServerIp to the SNTP server
# broadcast address for example 192.168.255.255
# Note: the .255 nibbles need to correspond with the dvrIpNetmask .0 nibbles.
# For the 192.168.255.255 example the dvrIpNetmask must be 255.255.0.0
ntpUseSntp=no
#utcOffset options are -12..14
utcOffset=-5
Network]
#DHCP is not supported, only static IP address, dvrIpGateway is an optional parameter, defaults to 192.168.1.1
dvrIpAddress=192.168.1.150
dvrIpNetmask=255.255.0.0
dvrIpGateway=192.168.1.1
#ttlMulticast - Time-To-Live for UDP multicast streaming (tsFileStreaming and ETH record targets)
#options are 1 through 32, ** defaults to 4 if not set
ttlMulticast=4
[CanBus]
#canBusId options are 1, 2, 3 or 4 or 0 (disabled), ** defaults to 0
canBusId=0
[VideoSwitch]
#DVR can communicate with an AVC16xx (video-switch) via CAN bus.
#The video-switch has 1..N possible video routing options that can be commanded from the DVR upon DVR events
#Supported DVR events are: osdMenuOn, osdMenuOff
#For example: to enable video-switch routing option #2 when the OSD menu is visible set: osdMenuOn=2
#To disable the event set it to 0 i.e. osdMenuOn=0 will have no affect on video routing
#Note: CanBusId must be set to 1..4 above for this to have any affect i.e. canBus must be enabled
osdMenuOff=0
osdMenuOn=0
[Dimming]
#controlOled options are plus-minus-buttons, photo-cell, potentiometer
controlOled=plus-minus-buttons
#controlBezel options are plus-minus-buttons, photo-cell, potentiometer
controlBezel=plus-minus-buttons
#potentiometerType options are 28V, 5V
potentiometerType=5V
#midPointDay options are -1, 2 thru 15 ** defaults to -1 (calibrated defaults)
midPointDay=-1
#midPointNight options are -1, 2 thru 15 ** defaults to -1 (calibrated defaults)
To Next Page
Loading...
Need help?
General