Page | 88 of 105
AVR8414 Operation Manual – Rev O
# if videoInputs=ETH or target=ETH cloning is not supported
#eventMarkerDiscreteId options are 1, 2, 3 or 0 (do not mark events on discrete change)
#eventMarkerDiscreteState only applicable if eventMarkerDiscreteId=1 or 2 or 3 options are open or ground
#quality options are standard, medium, high, ultra or ultraCustom
# Note1: ultra is only valid when rec target, clone target (if enabled) and overflow target (if enabled)
# are INT, SSD or SD
# Note2: ultra is only valid for composite inputs if only one input is selected
# Note3: if ultraCustom is specified the user must set the custom bit-rate for ultra below
#ultraCustomKbps options are: 6000 through 18000, Note1: required parameter if quality=ultraCustom,
# ** defaults to 0
#recStartOn options are: manual, turn-on, discrete , discrete-toggle
#recStartOnDiscreteId, only applicable if recStartOn is discrete or discrete-toggle. Options are 1, 2 or 3
#recStartOnDiscreteState only applicable if recStartOnDiscreteId=1 or 2 or 3 options are open or ground
#capacityWarningPercent options are 15, 10 or 5 or 0 (disabled), ** defaults to 0
#udp-ip for example: udp-ip=192.168.1.44 Note1: required parameter if target=ETH
#udp-port for example: udp-port=1239 Valid Range is 1..65535 Note1: required parameter if target=ETH
# Note2: REC1 and REC2 must not have the same udp-port numbers
[REC1]
videoInputs=HD1
target=INT
clone=NONE
overflow=no
eventMarkerDiscreteId=0
eventMarkerDiscreteState=open
quality=medium
recStartOn=manual
recStartOnDiscreteId=1
recStartOnDiscreteState=open
capacityWarningPercent=0
udp-ip=192.168.1.50
udp-port=1234
[REC2]
videoInputs=SD1 SD2 SD3
target=SSD
overflow=yes
eventMarkerDiscreteId=0
eventMarkerDiscreteState=open
quality=standard
recStartOn=manual
recStartOnDiscreteId=1
recStartOnDiscreteState=open
capacityWarningPercent=0
udp-ip=192.168.1.50
udp-port=1235
[PLAYBACK]
#disableAudio, options are: yes or no -- if yes then all playback will be without audio ** defaults to no
disableAudio=no
#preferredVideoInput, if no user selected playback file is set the dvr will always attempt to play a file
# from this source (either live-playback or pre-recorded file)
# options are any one of: SD1, SD2, SD3, SD4, HD1, HD2 or NONE. ** Defaults to NONE
# if NONE is selected the DVR will play the first available recording source during live-playback
preferredVideoInput=NONE
#tsFileStreaming options are yes or no, ** defaults to no -- if set to yes the OSD file details page will
# have controls to start/stop TS file streaming
tsFileStreaming=no
#udp-ip for example: udp-ip=192.168.1.44 Note1: required parameter if tsFileStreaming=yes
udp-ip=192.168.1.50
To Next Page
Loading...
Need help?
General