Avaya Scopia XT5000

To Next Page

To Previous Page

• Enable remote upgrades and PCs allowed remote access as described in Enabling and

Securing Remote Upgrades on page 159. Be sure to use an allowed computer if you restricted

remote access to specific PCs.

• Download the update, or contact your local customer service representative.

Procedure

Verify the XT Series is connected to the network on the GLAN1

port.

Verify the computer can reach the XT Series, and that a firewall does not block TCP port

55099.

Figure 107: GLAN1 port

2. Download the upgrade package (for example, XT5000_Vxxx.exe) from the Avaya site to the

computer.

This can be used to upgrade any Avaya Scopia

XT Series.

3. On the computer, launch the upgrade file.

4. Enter the IP address of the XT Series in the start screen and select Start.

Figure 108: Upgrading the firmware of the XT Series

The upgrade is transferred to the XT Series.

Caution:

After download begins do not shut down the XT Series until download is completed. At

the end of the update, the system reboots automatically.

5. The upgrade procedure may automatically continue after the reboot, and therefore reboot

again. Wait a few minutes to ensure that the upgrade procedure is completed.

Do not turn off the XT Series before the upgrade procedure is completed.

Avaya Scopia XT5000 - Page 154