The certificate is validated and its details appear (Generating and Uploading a Certificate
Signing Request for XT Series on page 162).
Tip:
Verify the system's time is synchronized with SNTP, otherwise you may need to wait a
few hours before using this certificate (for details, see
Setting Date and Time on
page 93). You can start using this certificate from the time in the notBefore field in the
signed certificate.
Figure 118: Signed certificate from the CA
11. Continue with Enabling the TLS Connection in XT Series on page 167.
Related Links
Securing Connections to the XT Series Using TLS on page 160
Backing Up and Restoring XT Series Certificates
About this task
This section explains how to backup and restore certificates using a USB key to store the certificate
information. You can only perform this procedure from the endpoint's interface. If you want to delete
the certificates without first backing them up, proceed as explained in
Deleting XT Series
Certificates on page 166.
Procedure
1. Connect a USB key to the upper USB port of the XT Codec Unit (Figure 119: Connecting a
USB Key to the XT Codec Unit on page 166).
Securing Connections to the XT Series Using TLS
April 2015 Avaya Scopia
®
XT Series Deployment Guide 165
Comments? infodev@avaya.com