enable non-English characters, available on the web interface only. For more advanced settings of
the system name, see Configuring Advanced System Name Settings on page 152.
After initial setup, you can modify these settings by selecting Configure > General from the
endpoint's menus, or from the web interface select Basic Settings > Preferences > General.
Before you begin
Access the quick setup wizard from the endpoint or web interface, as described in
Configuring
Basic Settings with the Quick Setup Wizard on page 110.
Procedure
1. Define the name and language.
2. To adjust the image on your monitor, select Next and continue with Adjusting the Image
Position on page 112.
If performing the quick setup from the web interface, access the quick setup from the
endpoint to adjust the image. This can be done at any time.
Related links
Configuring Basic Settings with the Quick Setup Wizard on page 110
Adjusting the Image Position
About this task
You can center the endpoint's image correctly on its monitor in this stage of the Quick Setup
Wizard.
This is for deployments with a monitor connected to your Avaya Room System XT Series.
Procedure
1. Access the Quick Setup Wizard from the endpoint, as described in Configuring Basic
Settings with the Quick Setup Wizard on page 110.
2. Decide if the monitor's image needs adjusting, by verifying if the white border of the
triangles in the top left and bottom right corners are fully visible on all sides.
If the image is centered correctly, skip this procedure and select Next.
3. Press 1 to highlight the triangle in the top left corner in orange.
4. Use the arrow keys to position the image, so all sides of the white border of the triangle are
visible in the screen, then press ok/menu.
5. Press 2 to highlight the triangle in the bottom right corner in orange.
6. Adjust the image position in the same way, until all sides of the triangle border are visible,
then press ok/menu.
7. To continue with the Quick Setup Wizard, select Next (see
Configuring Basic Network
Settings on page 113).
Manually setting up the XT Series
August 2020 Deployment Guide for Avaya XT Series 112
Comments on this document? infodev@avaya.com
To Next Page
Loading...
