Table 66: Supported Combinations with Signed/Unsigned Packages
XT Mode Recovery Mode Normal Mode
Upgrade done by: PC/Management USB PC/Management USB/AT/WEB
A signed package:
9.0 or higher
Accepted XT >= 9.0:
Accepted
XT < 9.0: Not
accepted
Accepted XT >= 9.0:
Accepted
XT < 9.0: Not
accepted
An unsigned
package (lower
than 8.3)
XT <= 8.3.x: Accepted
XT >= 9.0: Not accepted
XT <= 8.3.x: Accepted
XT >= 9.0: Not accepted
7
Send the log file to your local customer support representative.
1. Remove the USB drive from the USB port of the Avaya Room System XT Series
2. Connect the USB drive to a computer.
3. Locate the upgrade.log file on the flash drive.
4. Send the log file to your local customer service representative.
Related links
Troubleshooting the Avaya Room System XT Series on page 254
Restoring Default User Settings
About this task
This procedure explains how to restore the default settings if necessary. You can do this from the
endpoint itself only.
Before you begin
If configuring from the endpoint, you must first enable advanced configuration, as described in
Enabling Advanced Maintenance on the XT Series on page 151.
Procedure
1. From the endpoint's main menu, select Configure > Advanced > Utilities > Restore
System > Factory Defaults.
7
*By default, the unsigned software package is not accepted. You can force the system to accept an unsigned package
by setting “Verify Signature” to No. For more information, see Table 55: Enabling remote upgrades on page 203.
Restoring Default User Settings
August 2020 Deployment Guide for Avaya XT Series 281
Comments on this document? infodev@avaya.com
To Next Page
Loading...
