Field Name Description
Use Default NTP
Servers, Server 1,
Server 2
If your organization uses an external Simple Network Time Protocol
(SNTP) server for synchronizing the system clock, select Yes. The XT
Series uses SNTP servers returned by Dynamic Host Configuration
Protocol (DHCP), if available. If not available, it uses a list of well-known
public servers on the Internet.
If your organization uses one or two internal NTP servers for that
purpose, select No and enter the server IP address in fields Server 1
and/or Server 2.
Refresh time (min) Enter the time period after which the system contacts the NTP server to
refresh the clock. (10...1000 minutes)
3. From the web interface only, select Save.
Related links
Configuring Basic Settings with the Quick Setup Wizard on page 110
Setting the Time Zone
About this task
You can set the time zone from your endpoint or the XT Series web interface.
Before you begin
If configuring from the endpoint, you must first enable advanced configuration, as described in
Enabling Advanced Maintenance on the XT Series on page 151.
Procedure
1. Access the time zone settings. From the XT Series web interface, select Administrator
Settings > System > Date & Time > Time Zone. From the endpoint's main menu, select
Configure > Advanced > System > Date & Time > Time Zone.
You need to enter the PIN required to access the Advanced settings. The default PIN is
1234.
Configuring Basic Settings with the Quick Setup Wizard
August 2020 Deployment Guide for Avaya XT Series 119
Comments on this document? infodev@avaya.com
To Next Page
Loading...
