EasyManua.ls Logo

Avaya XT Series - Connecting Multiple HDMI Devices or Cameras Via the Avaya XT Series Camera Switch

Avaya XT Series
306 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9. Enable the HD1 camera and configure its settings, as described in Configuring
Cameras on page 126.
If you connect Tracking camera TC220 as the second camera, enable the HD2 camera.
Related links
Connecting Cameras or DVD players on page 59
Connecting Multiple HDMI Devices or Cameras via the Avaya XT
Series Camera Switch
About this task
You can connect a second PTZ camera to your XT Series, for large room setups. All XT Series
models can connect the extra camera directly to the DVI port. However, the XT7000 and XT5000
can also connect it via the Avaya XT Series Camera Switch which is purchased separately. Using
the switch enables multiple HDMI connections and keeps the DVI port available for a computer or
DVD player to share content. For example, you may want to zoom one camera to focus on the
speaker, and use another camera for the audience.
On the XT7000 only, you can connect a second camera to an extra HDMI port on the XT Codec
Unit, without using the Avaya XT Series Camera Switch. Use the Avaya XT Series Camera Switch
when connecting more than two cameras to the XT7000.
With the Avaya XT Series Camera Switch, you can connect up to four HD cameras or HDMI
devices, like a DVD or other media player.
Connected cameras can be controlled from an XT7000 and XT5000 endpoint.
Important:
The Avaya XT4000 Series and Avaya XTE240 do not support the Avaya XT Series Camera
Switch.
Before you begin
Caution:
Make sure all units are switched off when connecting or disconnecting devices.
Always remove the camera stabilizing cartons before connecting the camera.
Do not place a camera on top of the XT Codec Unit. It can cause the system to overheat.
Procedure
1. Install the Avaya XT Series Camera Switch on a horizontal surface close to the XT Codec
Unit. The supplied cable length is 40cm (0.13ft).
2. Connect the USB and HDMI cables as follows (Figure 32: Connecting the Avaya XT Series
Camera Switch to the XT Codec Unit on page 68):
Connect one end of the HDMI cable to the OUTPUT socket on the Avaya XT Series
Camera Switch and the other end to the vertical HDMI connector on the XT Codec Unit.
Connecting Cameras or DVD players
August 2020 Deployment Guide for Avaya XT Series 67
Comments on this document? infodev@avaya.com

Table of Contents

Other manuals for Avaya XT Series

Related product manuals