4. To upgrade the XT Series, see Upgrading the software using a PC on page 204,
Upgrading the software using a USB drive on page 205, Upgrading the Software Using a
Web Browser on page 206, Upgrading the Software Using Avaya Meetings
Management on page 207 or Upgrading the Software Using the Over The Air (OTA)
Method on page 207.
Upgrading the software using a PC
About this task
This section describes how to upgrade the software running on the Avaya Room System XT
Series by downloading the upgrade package to a computer on the network.
Before you begin
• If you upgrade to a major version, ensure you have a new license key (for details, see
Activating the XT Series and its Optional Features on page 105).
• Verify that this PC is allowed to remotely manage this XT Series (enabled by default. See
Securing Web Access to the XT Series on page 232).
• Enable remote upgrades and PCs allowed remote access as described in
Enabling and
Securing Upgrades on page 202. Be sure to use an allowed computer if you restricted
remote access to specific PCs.
• Download the update, or contact your local customer service representative.
Procedure
1.
Verify the XT Series is connected to the network on the GLAN1
port.
Verify the computer can reach the XT Series, and that a firewall does not block the
following port:
• 55099: If you have not enabled secure upgrades.
• 55090: If you have enabled secure upgrades, as described in
Enabling and Securing
Upgrades on page 202.
Figure 99: GLAN1 port
2. Verify that your computer is connected to the network using a cable.
The upgrade could take too much time through a wifi network.
Advanced Configuration of the XT Series
August 2020 Deployment Guide for Avaya XT Series 204
Comments on this document? infodev@avaya.com
To Next Page
Loading...
