2. Set the fields as described in the following table.
<auto > is the default setting. It indicates that the system tries to choose the settings that
best suit the local situation.
Table 39: Configuring bandwidth settings of a call
Field Name Description
IP > Rate (K) Sets the maximum bitrate used for a single point-to-point call.
Audio Coding Sets the preferred audio codec that the system tries to send. The
remote system must support the same codec for a successful
connection.
Video Coding Sets the preferred video codec that the system tries to send, if the
remote system supports the same codec.
H.239 or BFCP are not applicable to web collaboration.
DualVideoCoding Sets the resolution for H.264 content video.
Use manual DualVideo
bandwidth
If set to Yes allows to change bandwidth used for H.264 content
and live video (DualVideo/Live bandwidth).
DualVideo/Live bandwidth Sets more bandwidth on Live Video or H.264 Content.
ISDN > Rate (K) Sets the maximum call rate that the system uses for any ISDN
call.
3. From the web interface only, select Save.
4. Access the bandwidth limits for each network port. From the XT Series web interface,
select Administrator Settings > Networks > GLAN1/GLAN2 > Bandwidth. From the
endpoint's main menu, select Configure > Advanced > Networks > GLAN1/GLAN2 >
Bandwidth.
5. Set the fields as described in the following table:
Table 40: Configuring bandwidth settings of a call
Field Name Description
Enable Select Yes to enable limiting bandwidth for this network port.
Max. Bandwidth Rx (KB) Enter the incoming bandwidth limit for traffic on this network port,
measured in kilobytes (not kilobits) per second (KBps).
Max. Bandwidth Tx (KB) Enter the outgoing bandwidth limit for traffic on this network port.
Setting a Time Limit for Videoconferences
About this task
Set a time limit for videoconferences to alert users that the time allocated for the meeting is about
to end, and to end videoconferences that were left open.
Advanced Configuration of the XT Series
August 2020 Deployment Guide for Avaya XT Series 166
Comments on this document? infodev@avaya.com
To Next Page
Loading...
