Configuring Basic SIP Settings
About this task
This section explains how to register your XT Series to the SIP server.
The XT Series can function in a SIP environment, where endpoint names or numbers are
managed by SIP servers, not gatekeepers. You can dial an endpoint by entering its name or
number like 1234 or joe_smith, rather than remembering its IP address, where the SIP server
routes the call correctly. To do this, the SIP server must register all endpoints to maintain the
mapping list of names/numbers and endpoints to successfully route calls.
Before you begin
Access the quick setup wizard from the endpoint or web interface, as described in Configuring
Basic Settings with the Quick Setup Wizard on page 110, and skip to this step.
Verify that you have the following information about your SIP environment:
• The DNS name or IP address of the SIP server. You can define up to three servers.
• For the SIP infrastructure that requires a SIP user authentication, credentials for
authenticating XT Series to the SIP server.
Procedure
1. Enter information for the SIP server, as described below.
In redundant SIP deployments, the XT Series uses this server as the default SIP server.
Table 17: Configuring basic SIP settings for the XT Series
Field Description
User Enter the system name (or number). The system is registered to
the SIP server under this name.
When connecting over SIP, this name is displayed on the monitors
participating in the videoconference (for example, John-Smith, or
9th-Floor-Room) .
Authentication Name If necessary, enter the name for authenticating the XT Series with
the SIP server. It can be the same as the User parameter.
Authentication Password If necessary, enter the password for authenticating your XT Series
with the SIP server.
Use SIP Server Enable registering the system to the SIP server by selecting Yes.
For redundant SIP deployments, you can enter information for up
to three SIP servers, as described in Registering the XT Series to a
SIP Server on page 133.
Server Address Enter the DNS name or IP address of the SIP server, used to
register the endpoint.
2. Select Done to complete the Quick Setup Wizard.
Configuring Basic Settings with the Quick Setup Wizard
August 2020 Deployment Guide for Avaya XT Series 115
Comments on this document? infodev@avaya.com
To Next Page
Loading...
