Standby or activate.
Press and hold to
switch off.
Enter numbers or characters.
Hold to recall preset.
Open Contacts
Dial a call
Disconnect or
end a meeting
Press and hold
to toggle Do not disturb
Press to select a menu item.
Long press to change input mode.
Back/undo.
Toggle graphic
menu on
home page.
Press to delete.
Hold to clear.
Toggle graphic
menu everywhere.
Start/end
presentation
(Arrow keys)
Navigate menus.
Move camera.
Press red and green keys
to activate programming mode.
Enter two digits to program.
Zoom
Volume
Press to toggle video mute.
Hold to toggle Do not disturb.
Press to toggle audio mute.
Hold to toggle privacy.
Help
Press to change input source.
Hold to toggle local/remote.
Press to change multi-image type.
Hold to toggle Open layout page.
Change layouts
Press to select
far end
Press to select
near end
Press Memo then enter
two digits to position
near camera as preset.
Press Select then enter
two digits to select
saved near or far preset.
Figure 67: The XT Remote Control Unit (Advanced)
Enter letters and digits into a field using the remote's keypad on the XT Remote Control Unit. The
system displays the current entry method to the right of the field. You can switch entry methods by
pressing the 1/a/A button repeatedly while the cursor is in the input field, to switch between abc1
(default) for lower case alphanumeric characters, ABC for upper case characters only (no digits),
abc for just lower case characters only (no digits), and 123 for digits only. To enter a letter or
number, press a key repeatedly to cycle through its characters.
About the XT Remote Control Unit
August 2020 Deployment Guide for Avaya XT Series 141
Comments on this document? infodev@avaya.com
To Next Page
Loading...
