Figure 17: Camera scope covers all seats
All cameras should be at a height to ensure eye contact between local and remote
participants.
Try positioning the camera between the two monitors either directly above or below them, at
a distance which captures all the seats.
Caution:
Do not place the camera on top of the XT Codec Unit. It can cause the system to
overheat.
Place chairs so that you and other participants appear in full frame of the cameras, in the
middle of the monitors.
For the Tracking camera TC220, place the camera 1.4-1.8 meters height from the floor. See
Figure 19: Tracking camera TC220 placement in relation to table on page 55 for the camera
placement with respect to the room table. The center of the camera should be slightly to the
left of the center of the table.
Setting Up the XT Series Hardware
August 2020 Deployment Guide for Avaya XT Series 54
Comments on this document? infodev@avaya.com
To Next Page
Loading...
