Avaya XT Series - Page 71

XT Camera Switch
Connected to XT5000
XT Camera Switch
Connected to XT7000
Second Camera
First Camera
Figure 36: Connecting the second camera
• Attach one end of the VISCA control cable to the IN RS-232C connector on the
second camera.
• Attach the other end to the OUT RS-232C connector on the previous camera.
b. Connect the DVI-HDMI cable:
• Attach the DVI connector to the DVI socket on the second camera.
• Attach the HDMI connector to the HDMI socket labeled 2 for the XT5000 and to the
socket labeled 1 for the XT7000 on the Avaya XT Series Camera Switch.
6. If required, repeat the above step for a additional HDMI devices.
7. Check that the SYSTEM SELECT switch on the back panel of each camera is set to 7:
This is only for Premium, Advanced, and Standard II cameras.
Figure 37: Checking the SYSTEM SELECT switch
Caution:
To adjust the switch, you must first turn the camera off. Adjust it using a slotted 2.5 mm
screwdriver.
8.
Turn on the XT Codec Unit by pressing the power key on the XT Remote Control Unit.
This also turns on the Avaya XT Series Camera Switch.
9. Connect one end of the power supply cable to the DC IN 12V connector on each camera,
and the other end into one of the power sockets on the wall.
Connecting Cameras or DVD players
August 2020 Deployment Guide for Avaya XT Series 71
Comments on this document? infodev@avaya.com