Safety instructions
AVENTICS | Marex 3D | R417003094–BDL–001–AA 11
English
2 Safety instructions
2.1 About this chapter
All components of the ship remote control Marex 3D have been
manufactured in compliance with the generally accepted rules
of technology. However, this does not exclude the risk of
damage to persons or property if the general safety instructions
in this chapter and the safety instructions in this document are
not observed.
O Read this operating manual completely before operating the
Marex 3D system.
O Keep this manual in a location where it is accessible to all
users at any time.
O Always include this manual when passing Marex3D on to
third parties.
2.2 Intended use
Marex 3D may be used as follows:
W To operate ships with fixed propellers equipped with diesel
or electric engines, one bow and, optionally, one stern
thruster.
ID Identifier = Identification No. for CAN bus components
INMARSAT International Maritime Satellite Organization
Worldwide satellite radio service
ECR Engine control room
FPP Fixed Pitch Propeller
MPC Marine Propulsion Controller, control unit of
Marex OS III
NC Normally closed (contact)
NMEA National Marine Electronics Association
Communication standard for navigation instruments
on ships
NO Normally open (contact)
PS, PORT Portside
SB, STBD Starboard
Abbreviation Meaning
3D_manual_R417003094_DE_EN.book Seite 11 Freitag, 30. November 2018 11:36 11
To Next Page
Loading...
