Accessories
92 AVENTICS | Marex 3D | R417003094–BDL–001–AA
O Only replace batteries if the relevant device is disconnected
from the power supply and powered off.
8.3 Maintenance
Marex 3D components do not require maintenance. The
maintenance extends to inspection and cleaning as explained in
chapters 8.1 and 8.2.
It may be necessary though to open the 3D Controller if your
system configuration has changed or for troubleshooting.
O Make sure such modifications at the 3D Controller are only
done by authorized personnel as per chapter 2.4, Personnel
qualifications, on page 12.
9 Accessories
CAUTION
Injury hazard due to dangerous voltage or other risks
When opening the covers of Marex 3D components you may
be exposed to dangerous voltages or other risks. Only the
cover of the Marex 3D Controller may be opened. Do not open
any other covers for service or inspection.
O Do not attempt to repair a damaged component yourself.
O In case of malfunctions, contact AVENTICS or authorized
personnel as per chapter 2.4.
Table 4: Marex 3D accessories
Name Material No.
Bus distributor CAN
male
female
R419800372
R419800162
Terminating resistor M12 120 Ohm
male
female
8941054264
8941054274
NMEA S-Link interface adapter, 0.5 m R417003207
Sleipner interface (to be ordered from Sleipner)
Service package "ParaEdit 2.0" R419300325
3D_manual_R417003094_DE_EN.book Seite 92 Freitag, 30. November 2018 11:36 11
To Next Page
Loading...
