Troubleshooting
98 AVENTICS | Marex 3D | R417003094–BDL–001–AA
Impact on ships with bow and stern thrusters
If your ship is equipped with bow and stern thrusters, a thruster
failure will have the following consequences:
W The ship will turn slower and the pivot point will shift in
direction of the faulty thruster.
W Lateral shifts will no longer be possible. The bow will swing
towards port or starboard depending on which thruster has
failed.
W There will be no heading compensation.
There will be no restriction for maneuvers to ahead or astern.
Impact on ships with bow thruster
If your ship is equipped with a bow thruster only, the failure of
the thruster will have the following consequences:
W The ship will turn slower and the pivot point will drift
backwards towards the main propulsions.
W Lateral shifts are no longer possible. The bow will swing to
port when a lateral shift to starboard shall be performed
and reverse.
W There will be no heading compensation.
There will be no restriction for maneuvers to ahead or astern.
Be aware that Marex 3D cannot detect if all drives function
suitably for 3D-mode. Always observe thoroughly if the ship
behaves as expected when maneuvering in 3D-mode. If you
state deviations from the normal operation, release the
joystick so that the driving units are not longer actuated.
Use the control head to check every drive separately.
10.5 Errors at the 3D controller
The following picture shows the normal display of the 3D
controller including the operation elements.
3D_manual_R417003094_DE_EN.book Seite 98 Freitag, 30. November 2018 11:36 11
To Next Page
Loading...
