Aventics Marex 3D - Connecting an Optional Heading Sensor

Installation
AVENTICS | Marex 3D | R417003094–BDL–001–AA 49
English
5.3.4 Connecting an optional heading sensor
Fig. 23: Heading sensor R419801301
Fig. 24: Connection of the heading sensor R419801301
The optional heading sensor is connected to connector X32 at
the 3D Controller, using the sensor cable NMEA 2000
R419801829. An NMEA distributor is available to connect
further devices if necessary. The sensor cable can be extended
by a CAN bus cable M12, 894605xxx2. See also chapter 9,
3D_manual_R417003094_DE_EN.book Seite 49 Freitag, 30. November 2018 11:36 11