Aventics Marex 3D

To Next Page

To Previous Page

About this product

AVENTICS | Marex 3D | R417003094–BDL–001–AA 23

English

4.2.1.3 Marex ECS - single engine

3D_manual_R417003094_DE_EN.book Seite 23 Freitag, 30. November 2018 11:36 11

Main Page

Table of Contents3
About this Documentation6
Validity of this Documentation6
Required and Additional Documentation6
Information Presentation7
Safety Messages7
Symbols8
Designations9
Abbreviations10
Safety Instructions11
About this Chapter11
Intended Use11
Improper Use12
Personnel Qualifications12
Qualification of Mechanics and Service Technicians12
Qualifications of Operators13
General Safety Instructions13
Product- and Technology-Related Safety Messages14
Operator's Obligations15
Protective Devices16
Emergency Stop16
Visual Alarms and Acoustic Signals16
General Notes Regarding Property Damages and Product Damages16
About this Product17
Performance Description17
Drive Combinations19
Product Description19
System Setup and Symbols19
Control Stations24
Keys and Display25
Operation Modes25
Component Overview26
Joystick Type 53127
3D Controller30
Heading Sensor35
Applied Standards and Classification35
Installation36
Mounting the 3D Controller and Joystick Type 53136
Mounting the Heading Sensor37
Establishing the Electrical Connections39
Connecting the 3D Controller39
Connecting Marex os III and Marex ECS44
Connecting the Joystick47
Connecting an Optional Heading Sensor49
Connecting the Thrusters50
Commissioning58
General58
Software Requirements of Marex os and Marex ECS59
Verifying the Correct System Installation59
Installation Sites59
Reviewing the Cable Connections60
Preadjusting the 3D Controller61
Operation of the Display61
Adjusting the 3D Controller for the Operation with Marex os62
Enabling Control Stations for the Joystick Operation and Assigning the Joysticks64
Deactiving the Heading Sensor65
Adjusting Marex os for the Operation with Marex 3D66
Disabling the Direct Command Transfer67
Marex ECS in Combination with Marex 3D68
Thruster Parameter Settings68
Initial Operation69
Defining the Drive Combinations69
Tests and Adjustments69
Operation80
Switching Marex3D on80
Activating the 3D-Mode81
Switching the 3D-Mode off81
By Using the COM-Key at the Control Head81
By Movement of Control Head Lever (Direct Command Transfer)82
Activating the Thruster Mode82
Switching the Thruster Mode off83
Maneuvering in the 3D Mode83
Maneuvering in the Thruster Mode87
Thruster Mode with Proportional Thrusters88
Heading Mode90
Maintenance and Repair91
Cleaning and Care91
Inspection91
Maintenance92
Accessories92
10 Troubleshooting94
10.1 General94
10.2 Marex 3D94
10.3 Alarm Signals95
10.4 Possible Alarm Causes and Impact96
Propulsion Failure in 3D-Mode96
Thruster Failure in 3D-Mode97
10.5 Errors at the 3D Controller98
Error Display99
Error Specifications101
Error Messages102
10.6 Errors at the Marex os MPC107
Error Messages107
11 Alphabetical Index108

Aventics Marex 3D - Page 23

Table of Contents

Other manuals for Aventics Marex 3D