Axia Element - Monitor Section Screen; General Monitor Options

5: Show Proles • 90
©2008 Axia Audio — Rev. 3.0
Aux Return 1 / 2 Panorama Setting: Trim Pan/
Balance for the selected Aux Return, or Retain Ex-
isting Setting.
Aux Return 1 / 2 Assign to PGM1 / PGM2 /
PGM3 / PGM4: Choose On to fold the selected Aux
Return into any of the four PGM buses, or choose
Retain Existing Setting.
Aux 1 / 2 Source ID: If this drop-down box looks
familiar, that’s because it’s just like the ones you
used earlier to construct Source Profiles and map I/O
to Axia Audio Nodes. Click in the box and select the
audio device that will be providing source audio for
the Aux 1 or Aux 2 Return.
Save Changes button applies any changes made to
the Auxiliary Send Description and returns you to
the Show Profile Settings menu.
Back to Show Prole link takes you back to Show
Profile Settings without saving changes.
Monitor Section Screen
The Monitor Section Data screen captures the Moni-
tor settings found in Element’s Monitor Options menus.
Since you’re working on a “captured” Show Profile, this
page will, of course, mirror the choices you made when
you set up Element in the beginning of this chapter.
From the Show Profile Settings web page, choose the
Monitor Section Data link (refer to Figure 5-4). You’ll
find the page divided into four sections: general options,
Control Room Monitor options, Control Room Head-
phone options, and Studio Monitor options.
General Monitor Options
TIMER MODE: Lets you decide globally how the
onscreen Count Up (event) timer will behave when
this profile is loaded:
Choose Manual to start, stop and reset the timer
by hand using the controls displayed when the
Timer Options key is pressed.
Choose Auto-Reset and the timer will automat-
•
•
•
•
•
•
»
»
ically reset to zero and begin counting whenever
a fader is turned On.
Choose Auto-Add to have the timer count up
when a fader is turned On and stop counting
when that source is turned Off. In this mode, the
timer will not reset to zero when it is restarted.
SHOW TENTHS ON: Allows you to set the Count-
down and Count Up timers to show or hide tenths of
a second displays. Choices are:
No Timers: tenths of a second are hidden on
both timers.
Down Timers: tenths are shown only on Count-
down timers.
Up Timers: tenths are shown only on Count Up
timers.
Both Timers: All timers display tenths of a sec-
ond readouts.
FADER MODE: Sets the fader behavior globally for
this Show Profile. Choose from:
Normal: faders are turned on and off manually.
Fader Start: faders turn on when the fader is
raised and off when it is lowered to ∞.
Retain Source Setting: Each individual fader
behaves as its Source Profile dictates.
PREVIEW INTERLOCK MODE: If Enable is chosen,
pressing any fader’s Preview key causes any other,
previously-lit Preview key to be extinguished, re-
moving that source from Preview. The board opera-
tor can assign multiple faders to Preview by push-
ing and holding any lit Preview key while pushing
other Preview keys to add or subtract.
If Disable is chosen, each Preview key works like
a press-on, press-off latching switch. Multiple fad-
ers can be assigned to Preview simply by pushing
once; a second push cancels any individual Preview
assignment.
SWITCHED METER SOURCE SELECT: Choose
whether the far-right on-screen meter bars will dis-
play levels for the PROGRAM (PGM-4) bus, the
source feeding the Control Room Monitors (Moni-
»
•
»
»
»
»
•
»
»
»
•
•