Axia Element - Page 98

5: Show Proles • 88
©2008 Axia Audio — Rev. 3.0
Active or Bypass, or choose Retain Source Set-
ting. (Only applies to Mic sources.)
NOISE GATE THRESHOLD: Determines the point
at which the Noise Gate will operate (if set to Ac-
tive). Adjustment range is between 0dB and -50dB,
or Retain Source Settings.
COMPRESSOR THRESHOLD: Determines the point
at which the Compressor will operate (if set to Ac-
tive). Adjustment range is between 0dB and -30dB,
or Retain Source Settings.
DE-ESSER THRESHOLD: Determines the point at
which the Compressor will operate (if set to Active).
Adjustment range is between 0dB and -20dB, or Re-
tain Source Settings.
COMPRESSOR RATIO: Sets the amount of com-
pression that will be applied to the mic audio. Ad-
justment range is between 1:1 and 16:1, or Retain
Source Settings.
DE-ESSER RATIO: Sets how aggressively the
de-esser will remove sibilance from the mic audio.
Adjustment range is between 1:1 and 8:1, or Retain
Source Settings.
NOISE GATE DEPTH: Sets the amount of noise
reduction that will be applied to the mic audio if
the noise gate is set to Active and the Noise Gate
Threshold is reached. Adjustment range is between
0dB and -30 dB, or Retain Source Settings.
COMPRESSOR MODE: Change the voice compres-
sor between Freeze and No Freeze modes, or Re-
tain Source Settings.
BACKWARD FEED DIM GAIN: Set how much the
program audio being fed back to this source will be
dimmed when the source is being talked to using the
Talkback feature. Adjustment range is 0dB to -30dB,
or Retain Existing Setting.
CHANNEL ON/OFF STATUS: Allows you to turn
•
•
•
•
•
•
•
•
•
fader On or Off when the Show Profile is loaded.
CONTROL LOCK MAP: Place a check mark in any
of these boxes to keep the board op from changing
the selections for this fader’s bus assignments, On/
Off state and fader position.
About Channel Lock and Fader Operation:
Say that your station runs syndicated program-
ming overnight, and you want to eliminate the
possibility that the feed could be inadvertently
disrupted. Choose Lock for the channel the feed
is assigned to, and the channel cannot be turned
off, or bus assignment changed, until the chan-
nel is unlocked.
Note that there is currently no option to allow
presetting the fader gain. When you load a Show
Prole which species a Locked fader, the gain
value is locked to the position of the fader at the
moment the Show Prole is loaded.
When you Unlock the fader using the Chan-
nel Options menu, the fader will resume work-
ing normally from the current position. You can
move it and lock again in a different position if
you wish.
If the fader has been moved, the rst touch af-
ter Unlocking immediately resets the gain to
the fader’s current position.
GROUP START: Specify whether this fader is a
Master, Slave or Independent. This setting is
tied to those displayed in the Show Profile Group
Start Screen; a change made here will apply on the
Group Start Screen, and vice-versa. (For more in-
formation on the Group Start Function, please refer
to the Group Start Screen description later in this
chapter.
MOTOR FADER POSITION: Motorized Element
faders can be set to assume a predefined position
when a Show Profile is loaded. Choose Off to disable,
Use to specify a level to use (from -73 dB to +10 dB),
or Retain Existing Setting.
•
•
•