x
5 - 5 Set Point (SP) 5-32
SP setup in operation display mode 5-33
LSP system group 5-33
SP ramp type 5-33
RSP input range type 5-33
RSP range low limit/high limit 5-34
RSP ratio and RSP bias 5-34
RSP filter 5-35
RSP low limit/high limit and RSP low limit/high limit alarms 5-35
RSP and LSP1 to 8 5-35
PID group number 5-36
LSP group number 5-36
DI Assignment of LSP group selection 5-37
SP ramp unit 5-38
SP ramp-up/ramp-down 5-38
SP multi-ramp 5-40
SP low limit/high limit 5-42
DI Assignment of SP ramp enabled/disabled 5-42
5 - 6 Step Operation 5-43
LSP system group 5-43
SP ramp type 5-44
SP ramp unit 5-45
STEP time unit 5-45
STEP PV start 5-46
STEP loop 5-47
STEP operation LSP, PID group No., ramp, time 5-48
Operation type of internal contact 5-50
5 - 7 Digital Input (DI) and Internal Contact 5-51
Operation type 5-52
Internal event No. assignment 5-53
Input bit function 5-54
Input assignment 5-55
Polarity of input assignment 5-56
Polarity of input bit function 5-57
DI Assignment setting with the SLP-C35 Smart Loader Package 5-57
5 - 8 Internal Event 5-58
Operation 5-59
Operation type 5-65
Direct/reverse, standby, and EVENT state at READY 5-66
Alarm OR, special OFF setup, and delay time unit 5-67
Main setting, sub setting, and hysteresis 5-68
ON delay and OFF delay 5-69
5 - 9 Digital Output (DO) 5-71
MV1/MV2 process 5-72
Operation type 5-74
Output assignment 5-75
Polarity of output assignment 5-77
Polarity of output bit function 5-78
To Next Page
Loading...
