11.Click Install.
The system installs the iVu Plus GSD file and places it in the Hardware catalog. In the above example, the iVu Plus
GSD file is located under Other field devices > PROFINET IO > Sensors > Banner Engineering Corp. > Banner
Vision Sensors > iVu Series.
NOTE: If the iVu Plus GSD file does not install properly, save the log and contact Banner
Engineering Corporation.
Adding a Device to a Project
Use these instructions to add an
iVu Plus TG device to a Siemens TIA Portal (v13) project, and to configure the device. Use
these instructions as a basis for adding an iVu Plus TG device to another controller (PLC).
1. Start the Siemens TIA Portal (v13) software.
2. Click Open existing project.
3. Select a project and open it.
iVu Plus TG Gen2 Image Sensor
160 www.bannerengineering.com - Tel: 763.544.3164
To Next Page
Loading...
