Banner iVu Plus TG Gen2 - System Configuration; Save to Usb; Load from Usb

5.4.2 System Configuration
Main Menu > System > Configuration
The Configuration menu
options are:
• Save sensor Configuration to the USB flash drive
• Load sensor Configuration from the USB flash drive
• Reset the sensor Configuration to defaults
Save to USB
Main Menu
> System > Configuration > Save to USB
The Save to USB screen allows the sensor Configuration to be saved to a USB flash drive. The saved configuration
information can be used as a backup or as a way to clone configuration information for other sensors.
NOTE: On the Emulator, this option is Save Configuration.
Load from USB
Main Menu
> System > Configuration > Load from USB
The Load from USB screen allows the sensor Configuration to be restored from a USB flash drive. This operation removes
all existing inspections and replaces them with inspections contained in the configuration file on the USB flash drive.
NOTE: On the Emulator, this option is Load Configuration.
Reset to Defaults
Main Menu > System
> Configuration > Reset to Defaults
Resets all sensor configurations to the factory defaults. This operation will remove all existing inspections and replace them
with factory default settings.
iVu Plus TG Gen2 Image Sensor
38 www.bannerengineering.com - Tel: 763.544.3164