12 LED Indicator Troubleshooting
In normal operation, the Power LED is steady green, and the Pass/Fail is green or red depending on the triggered
inspection. The Ethernet I/O LED will be lit or off depending on connection status.
1 Power LED Green: Power
Red: Error
2 Pass/Fail LED Green: Pass
Red: Fail
3
Ethernet I/O LED
Green: Connected
No Light: Disconnected
The iVu also indicates abnormal conditions as described below.
12.1 Errors
Problem Indicator Solution
The Pass/Fail LED is blinking green a number
of times, separated by an LED red blink, and
the sensor repeats this pattern over and over.
This indicates that no inspections are
occurring.
Reboot the sensor.
The Power LED is lit steady red. These type of
errors are reported in the System log and
appear highlighted in red.
Do the following:
1.
Look in the System Log to see the error.
2. Clear the LED; that is, go to the Main Menu > Logs > System
Logs and press the Clear System Error button at the bottom of
the screen (a sensor reboot is not required).
3. If the error occurs again, you can try rebooting the sensor to see
if that fixes the problem. If the problem persists, contact Banner
customer support.
12.2 Warnings
Warnings are atypical conditions that the sensor detects and fixes. Warning are highlighted in yellow in the System Log,
and can typically be ignored.
iVu Plus TG Gen2 Image Sensor
www.bannerengineering.com - Tel: 763.544.3164 203
To Next Page
Loading...
