Banner iVu Plus TG Gen2 - Focus; Strobe

5.3.5 Focus
Main Menu > Imager > Focus
The Focus Number
displayed at the bottom of this screen is used to fine-tune image focus. Loosen the lock on the lens
cover, turn the focus ring on the sensor until the Focus Number peaks (or the image appears sharp), then lock the focus
ring.
NOTE: For the Focus Number to work, the sensor must be triggering and the images must be similar
over time.
5.3.6 Strobe
Main Menu > Imager
> Strobe
The Internal Strobe configures the operation of the integrated ring light. The External Strobe configures the operation of
an external light.
iVu Plus TG Gen2 Image Sensor
34 www.bannerengineering.com - Tel: 763.544.3164