Banner iVu Plus TG Gen2 - Gain; Trigger

NOTE: This feature is not effective on the emulator.
5.3.3 Gain
Main Menu
> Imager > Gain
Gain is an electronic boost to the image signal. Increasing Gain by using the '-' and '+' keys or moving the slider to the
right increases image brightness without increasing exposure time. Note that Gain brightens both the light pixels and dark
pixels and may reduce the image quality.
NOTE: This feature is not effective on the emulator.
5.3.4 Trigger
Main Menu > Imager > Trigger
A Trigger
is a signal that makes the sensor capture an image and inspect it. Use the dropdown list to selectExternal
Trigger, Internal Trigger (default), Free Run, Industrial Ethernet Only, or Command.
• If Internal Trigger is selected, triggers are based on timed intervals, and you need to select a trigger interval
between 10 and 10000 milliseconds.
NOTE: If the interval is less than the inspection time, then missed triggers will occur.
• If External Trigger is selected, inspections are triggered in response to an electrical signal on the Trigger input
line.
•
If Free Run is selected, the sensor automatically runs continuous inspections.
• If Command is selected, the command channel is used to trigger the sensor from a remote device.
• If Industrial Ethernet Only is selected, trigger commands from the Industrial Ethernet communications channel
only are accepted.
iVu Plus TG Gen2 Image Sensor
www.bannerengineering.com - Tel: 763.544.3164 33