5.4.3 System Information
Main Menu
> System > Information
The Information screen displays the following sensor information:
• Serial Number
• Firmware Version
• Boot Number
• Up Timer—the time elapsed since last boot of the sensor
• Hour Count—the total hours of operation in the sensor's lifetime
• Model Number
• Device Name
Click the right-arrow next to the Sensor Name field to display a software keyboard that allows you to change the Sensor
Name. You may set the sensor name in English on the device. To set the sensor in any other language, please use the
Emulator software.
5.4.4 Lock Device
Main Menu > System > Lock Device
This option provides for locking the sensor to prevent accidental modification of settings. When locked, the sensor only
provides access to pass/fail statistics, as well as the ability to view logs and to save them to a USB device. A lock icon in
the upper left corner of the sensor display indicates that the sensor is locked. Note that the sensor can be locked with or
without a password. If a password is not used, unlock the sensor by clicking on the Unlock Device menu. When a password
is used, it must be 4 digits entered using the software keypad. If the password is lost, use the Password Reset Utility
software provided on the CD to obtain a Reset Key.
NOTE: This menu option is not available in the Emulator.
5.4.5 Communications
Main Menu > System > Communications
The Communications menu is used to configure the serial I/O channel. There are
six menu options:
• Ethernet I/O for configuring the Ethernet port
• Serial I/O for configuring the Serial port
• Industrial Ethernet settings
• Command Channel for sending commands to get specific data through Serial or Ethernet channels.
• Data Export Channel for enabling or disabling the channel for data export only
• Image Export Channel for enabling or disabling the channel for image export only
NOTE: Serial I/O can be configured either for Data Export or Command Channel. Image Export is only
available on Ethernet.
Ethernet I/O
Main Menu
> System > Communications > Ethernet I/O
iVu Plus TG Gen2 Image Sensor
www.bannerengineering.com - Tel: 763.544.3164 39
To Next Page
Loading...
