Coarse resolution has a maximum FOV of 376×240 pixels, and Fine resolution has a maximum FOV of 752×480 pixels.
Fine resolution has 4 times more pixels than Coarse resolution. Inspection performance may be affected when using Fine
resolution, depending on the application.
By default, the FOV is set to the default FOV size (320×240) in Coarse resolution
mode.
When a new resolution is selected, Match and Sort patterns must be taught again. A trigger is required before any on-
screen data is updated.
Any sensor within the inspection will use the selected resolution. Only one resolution is used per inspection.
5.4 System Menu
Main Menu > System
The System menu
icon is on the Main Menu, and is used to manage the sensor. The System menu provides for selecting
Sensor Mode, updating sensor firmware, backing up and restoring sensor Configuration, and other general system-level
operations.
5.4.1 Mode
Main Menu > System > Mode
The sensor has two operating modes:
•
Live Mode, which is the normal operating mode where the sensor captures live images, scans, and verifies
barcodes
• Demo Mode, where inspections are run on stored images and inspection parameters.
The first time the device is powered up it starts in Demo Mode and allows you to choose whether to stay in Demo
Mode or exit to Live Mode. Demo Mode uses stored images and inspection parameters that demonstrate how the
sensor is set up without having to worry about focus, lighting, or triggers. In this mode, practice making
adjustments while observing how the adjustments affect the results. To exit Demo Mode go to Main Menu >
System > Mode and select Exit Demo Mode. Upon exit, the sensor reboots into its normal operating mode with
default settings.
NOTE: Switch between Live Mode and Demo Mode any time by going to Main Menu > System >
Mode.
iVu Plus TG Gen2 Image Sensor
www.bannerengineering.com - Tel: 763.544.3164 37
To Next Page
Loading...
