Banner iVu Plus TG Gen2 - Command Channel Command Status Register; Diagnostic Guide; Ethernet Diagnostics

Verify :
Ready = 1
GatedTriggerACK = 0
Ready
Gated
Trigger
GatedTriggerACK
= ‘1 ’
Read Results
RPI 0 1 X X +Y X +Y + Z M N
Gated
Trigger ACK
Set
GatedTrigger
= 1
Verify :
Ready = 1
TriggerACK = 0
Set
GatedTrigger
= 0
Set
GatedTrigger
= 1
Set
GatedTrigger
= 0 (Abort )
Inspection
could not be
completed
Gated Trigger
9.9 Command Channel Command Status Register
The command status is a verification of the command type.
Command Status Value (16-bit integer)
Unknown 0
Read 1
Write 2
Execute 3
9.10 Diagnostic Guide
iVu Plus sensors provide several methods to help diagnose communication issues when using Ethernet communications.
9.10.1 Ethernet Diagnostics
To verify Ethernet connectivity, follow these steps:
1.
Verify that all the cables are connected and properly seated.
iVu Plus TG Gen2 Image Sensor
182 www.bannerengineering.com - Tel: 763.544.3164