3. Select Internal Trigger on the Trigger Selection screen (Main Menu
> Image > Trigger).
4. Set the Trigger Interval as desired.
The iVu Emulator runs using the .bmp files from Step 1.
NOTE: Banner does not recommend setting up inspections using these 8-bit grayscale images because
you will always end up modifying the configuration after loading it on the sensor on the line. A better
choice is to set up the inspection on the iVu Emulator using the Inspection Logs from the sensor.
iVu Plus TG Gen2 Image Sensor
202 www.bannerengineering.com - Tel: 763.544.3164
To Next Page
Loading...
