14.Click Accessible devices.
The Select device window searches the network for available devices.
15.
Determine the device to be adjusted via the MAC address and select it.
NOTE: Use the iVu Plus touch screen to find the MAC address. Main Menu
> System >
Communications > Ethernet IO > Status
16.Click Apply.
The IP address for the device is updated.
17.
Click Assign IP address to complete the step.
This step is completed for every device.
Changing the Device Name
Use these instructions to change the name of the iVu Plus TG device, using the Siemens TIA Portal (v13) software. Use
these instructions as a basis if you are using another controller (PLC).
iVu Plus TG Gen2 Image Sensor
166 www.bannerengineering.com - Tel: 763.544.3164
To Next Page
Loading...
