8. Click OK.
The Edit Ethernet Node window is updated.
9.
Set the IP address to the desired value.
10.Click Assign IP Configuration at the bottom left of the Set IP configuration section.
The parameters are transferred.
11.Click OK to acknowledge the message of a successful transfer.
The IP address adjustment is complete.
Changing the Device Name
Use these instructions for the Siemens SIMATIC STEP 7 (v5.5) software.
1.
Start Siemens SIMATIC Manager.
2. Select an existing project and open it.
iVu Plus TG Gen2 Image Sensor
www.bannerengineering.com - Tel: 763.544.3164 175
To Next Page
Loading...
