1.
Use the brackets to set a tolerance for the pass/fail.
Now the inspection for the blemish sensor is set up to be sensitive enough to find blemishes under the logo
and fail the inspection.
3.
Test the complete range of good and bad samples to make sure that the sensor accepts good parts and rejects bad
parts.
4. To complete the Blemish application setup, set triggering as appropriate for the application.
NOTE: Remote Teach does not work with the Blemish Sensor type.
iVu Plus TG Gen2 Image Sensor
66 www.bannerengineering.com - Tel: 763.544.3164
To Next Page
Loading...
