Examples
>> set trigger mode command\x0D\x0A
<< OK\x0D\x0A
>> get trigger mode\x0D\x0A
<< OK\x0D\x0A
<< Command\x0D\x0A
>> do trigger\x0D\x0A
<< OK\x0D\x0A
Imager Command Group
Command Group Item Description
Get Imager Gain The sensor's value used to electronically brighten all image
pixels This value can be modified using the sensor's
touchscreen. This remotely modified value is not persisted to the
sensors permanent memory. The 'Save' operation is required to
persist this value.
Set Imager Gain The sensor's value used to electronically brighten all image
pixels This value can be modified using the sensor's
touchscreen. This remotely modified value is not persisted to the
sensors permanent memory. The 'Save' operation is required to
persist this value.
Get Imager Exposure The sensor's value used to control the amount of time the
imager is allowed to gather light for the image. This value can
be modified using the sensor's touchscreen. This remotely
modified value is not persisted to the sensors permanent
memory. The 'Save' operation is required to persist this value.
Set Imager Exposure The sensor's value used to control the amount of time the
imager is allowed to gather light for the image. This value can
be modified using the sensor's touchscreen. This remotely
modified value is not persisted to the sensors permanent
memory. The 'Save' operation is required to persist this value.
Examples
>> get imager exposure\x0D\x0A
<< OK\x0D\x0A
<< Command\x0D\x0A
>> set imager exposure"11900"\x0D\x0A
<< OK\x0D\x0A
Teach Command Group
Command Group Item Description
Do Teach NextTrigger This commands forces the sensor to perform the Remote Teach
operation on the next trigger. This command can be performed using
the sensor's touchscreen.
Examples
>> do teach\x0D\x0A
<< OK\x0D\x0A
iVu Plus TG Gen2 Image Sensor
www.bannerengineering.com - Tel: 763.544.3164 93
To Next Page
Loading...
