Basler DECS-200 - Page 136

6-8 Setup DECS-200
Enter the high-level current setpoint for off-line overexcitation limiting ........................................ ________
Enter the duration for high-level, off-line overexcitation limiting ................................................... ________
Enter the low-level current setpoint for off-line overexcitation limiting.......................................... ________
Enter the high-level current setpoint for on-line overexcitation limiting ........................................ ________
Enter the duration for high-level, on-line overexcitation limiting ................................................... ________
Enter the medium-level current setpoint for on-line overexcitation limiting .................................. ________
Enter the duration for medium-level, on-line overexcitation limiting ............................................. ________
Enter the low-level current setpoint for on-line overexcitation limiting.......................................... ________
Takeover OEL
If takeover style overexcitation limiting is enabled, configure the off- and on-line OEL settings illustrated in
Figure 6-10.
Figure 6-10. Setting Adjustments Screen, OEL (Takeover) Tab
Enter the low-level current setpoint for off-line overexcitation limiting.......................................... ________
Enter the high-level current setpoint for off-line overexcitation limiting ........................................ ________
Enter the time delay for off-line overexcitation limiting ................................................................. ________
Enter the low-level current setpoint for on-line overexcitation limiting.......................................... ________
Enter the high-level current setpoint for on-line overexcitation limiting ........................................ ________
Enter the time delay for on-line overexcitation limiting ................................................................. ________
UEL
Set the underexcitation limiter values based on the generator capability curve. Either internal or
customized UEL settings can be applied. When internal UEL settings are used, only one data point is
required. When customized UEL settings are used, up to five data coordinates may be entered to match a
specific generator curve. Figure 6-11 illustrates the settings of the UEL tab.