Basler GigE SERIES User Manual

Index AW00089317000
364 Basler ace GigE
E
end of exposure event ...........................295
event overrun event ...............................295
event reporting .......................................295
exposure auto ........................................286
F
factory setup ..................................305, 306
auto functions factory setup.............305
color factory setup............................305
high gain factory setup.....................305
standard factory setup .....................305
frame
~ counter..........................................314
frame start overtrigger event..................295
frame start trigger...................................228
free selection sequence
~ set advance mode ........................251
G
gain ........................................................197
gain auto ................................................284
gain raw parameter................199
, 200, 202
global
~ shutter.............................54
, 119, 120
gray value
~ adjustment damping .....................289
H
high gain factory setup...................305, 307
horizontal
~ decimation ....................................267
horizontal binning...................................257
horizontal mirror image ..........................268
I
image distortion..............................262, 266
input line
electrical characteristics.....................64
propagation delay ..............................65
voltage requirements .........................63
L
line status .............................................. 241
lookup table........................................... 273
luminance lookup table.......................... 273
LUT........................................................ 273
LUT enable parameter........................... 275
LUT index parameter............................. 275
M
max height parameter............................ 302
max width parameter............................. 302
minimum output pulse width.................. 293
mirror image .......................................... 268
modes of operation (of auto functions).. 277
N
non-sequence parameter ...................... 225
O
output line
electrical characteristics.................... 67
response time.................................... 70
voltage requirements......................... 67
P
parameter limits, removing .................... 208
parameter sets
explained......................................... 305
parameters loaded at startup................. 309
PLC power and I/O cable ........................ 60
voltage requirements......................... 63
pylon Camera Software Suite.................. 45
R
reduced resolution......................... 261, 266
remove limits parameter........................ 208
removing parameter limits ..................... 208
restart
asynchronous.................................. 229
synchronous.................................... 229
reverse X............................................... 268
reverse Y............................................... 270

Basler GigE SERIES Specifications

General

Interface	GigE
Lens Mount	C-Mount, CS-Mount
Sensor	CMOS
Mount	C-mount, CS-mount
Power Supply	Power over Ethernet (PoE)
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	Varies by model