SYSTEM CONFIGURATION Chapter 8
8 - 17
8.4.6.1 IDLE ALARM
The IDLE ALARM option determines whether a PUMP IS IDLE condition will be indicated
by an alert or an alarm. This option allows one of two possible selections: Y or N.
Y A PUMP IS IDLE condition will be indicated by an alarm.
N A PUMP IS IDLE condition will be indicated by an alert.
8.4.6.2 SET NEAR END
The SET NEAR END configuration option allows the operator to customize <xxMIN alerts
(<x
xMIN EMPTY, <x
xMIN VOLUME LIMIT, <x
xMIN <protocol>
).
The pump displays SET NEAR END with a N response. Press CONFIRM to skip to the
BOLUS COMPLETE option or press ▲ or ▼ to change the response to Y and press
CONFIRM to access the settings.
If Y is selected, the pump displays a <xx> MINUTES prompt where <xx> is the current
number of minutes for a <xxMIN alert prior to an EMPTY or VOLUME LIMIT alarm. Press
CONFIRM to accept the current setting or enter a new value of 5 to 60 minutes and press
CONFIRM to complete the setting.
Next, the pump displays a <bb> BEEPS prompt where <bb> is the number of beeps for a
<xxMlN alert. Press CONFIRM to accept the current setting or enter a new value of 1 to 15
beeps and press CONFIRM to complete the setting.
8.4.6.3 BOLUS COMPLETE
The BOLUS COMPLETE option determines whether the BOLUS COMPLETE alert is
enabled. This option allows one of two possible responses: Y or N.
Y Enable the BOLUS COMPLETE alert.
N Disable the BOLUS COMPLETE alert.
8.4.6.4 DOSE COMPLETE
The DOSE COMPLETE option determines whether the DOSE COMPLETE alarm is
enabled. This option allows one of two possible responses: Y or N.
Y Enable the DOSE COMPLETE alarm.
N Disable the DOSE COMPLETE alarm.
To Next Page
Loading...
Need help?
General
