Chapter 8 SYSTEM CONFIGURATION
8 - 4
8.4 CONFIGURATION GROUPS
8.4.1 LIBRARY Group
The LIBRARY configuration group allows the operator to create and modify protocols and
protocol libraries, and to perform pump-to-pump configuration replication. To select the
LIBRARY group, confirm a Y response to the CONFIG LIBRARY prompt.
8.4.1.1 Library Access Code
The pump displays ENTER CODE. Enter the four digit library access code. Pumps are
shipped from the factory with a default library access code of “0000”.
• If an invalid code is entered the pump issues a CODE MISMATCH alert. Reenter the
code correctly. If three CODE MISMATCH errors occur, the pump skips to the CONFIG
MODES group prompt.
8.4.1.2 LIBRARY Group Functions
After the library access code is entered, the pump displays ▲ ▼ SELECT FUNCTION.
Press ▲ or ▼ to step through the available functions and press CONFIRM to select a
specific function. The following function selections are displayed in the sequence shown:
1. QUIT 6. CREATE PROTOCOL
2. MODIFY PROTOCOL 7. CREATE LIBRARY
3. DELETE PROTOCOL 8. CHANGE CODE
4. MODIFY LIBRARY 9. RECEIVE
5. DELETE LIBRARY
All functions except QUIT return to the ▲ ▼ SELECT FUNCTION prompt upon
completion. The previous function used is displayed as the first selection.
8.4.1.2.1 QUIT
Selecting QUIT causes the pump to exit the LIBRARY group and continue with the
CONFIG MODES prompt.
8.4.1.2.2 MODIFY PROTOCOL
The MODIFY PROTOCOL function allows the operator to modify all information contained
in a specific protocol.
If the pump displays ▲ ▼ SELECT LIBRARY, press ▲ or ▼ as necessary to select the
library containing the protocol to be edited, and press CONFIRM to complete the selection.
To Next Page
Loading...
Need help?
General
