FUNCTIONAL TESTS Chapter 4
4 - 3
It is recommended that a data sheet be kept each time this procedure is run. The data
sheet is located at the end of this chapter. Fill out the pump information at the top of the
data sheet before beginning this procedure. Specific sections in this procedure are
indicated by (*D*) in the text below. This indicates that a recording is required on the data
sheet for that section. As each section is completed, transfer any data collected to the
data sheet and indicate each result as “Pass” or “Fail.”
To complete the Operational Checks listed in this chapter (see section 4.2.10), the pump
being tested must be configured so that four of its group options match those listed below.
Refer to chapter 8, as necessary, to meet these requirements.
• “mL/hr” Mode: [Y] (Enabled)
• PSI Range: [H] (High)
• RATE Range: [H] (High)
• Volume Limit: [Y] (Enabled)
4.2.4 Visual Inspection: (*D*)
1. Look for damage, sticky residue, or any other condition that could influence
performance. Clean as necessary. Ensure that the barrel clamp is properly fitted to the
case. Check the security of the pole clamp (if used).
2. Examine the pump for any and all visual discrepancies (including cracks, deformations,
discoloration, labeling problems and other abnormalities).
3. Examine the charger plug and the charger port on the pump for signs of mechanical
damage. Pins in the charger plug must be straight and intact.
4.2.5 Charging Circuit Check: (*D*)
1. Connect the AC charger to the pump through the din connector (bottom connector) and
to an AC receptacle.
2. (*D*) Verify that the “ON CHARGE” LED is ON. The pump shall be connected to AC
power via the charger throughout the remaining functional tests and the “ON
CHARGE” LED must remain on during these tests.
To Next Page
Loading...
Need help?
General
