SYSTEM CONFIGURATION Chapter 8
8 - 19
8.5 ENTERING TEXT DATA
The following rules apply for entering library names, protocol names and the identifier
(IDENT) field:
• The current character position is indicated by flashing.
• A flashing underscore (‘_’) character is used to indicate a blank in the current character
position.
• The characters A through Z and ‘-’ are selected by pressing ▲ or ▼.
• The characters 0 through 9 are entered directly from the keypad.
• A blank character can be selected by pressing CLR.
• The next character position is selected by pressing EDIT.
NOTE
Only after identifier changes have been completed should CONFIRM
be pressed.
To Next Page
Loading...
Need help?
General
