pro+ Surface Instruction for Use (209196 REV 8) 93
Maintenance
Prepare the Bed for Use
a. If applicable, secure the surface flap at the foot end of the surface
using the footboard.
b. Plug the surface power cord (if applicable) and bed into AC
power.
MAINTENANCE
To help prevent injury and/or equipment damage, obey these warnings:
• Warning—Only facility-authorized persons should service the
pro+ surface.
• Warning—Do not use a surface that has a damaged cover or
surface core assembly.
SURFACE INSPECTION INSTRUCTIONS
1. Look at the product information label on the top and bottom covers
to determine the age of the top cover and surface core assembly.
The label is on the right side at the foot-end of the top and bottom
covers (see below).
The surface has two RFID tags, one
in the top cover and the other in the
surface core assembly. Baxter
Service persons use these tags to
locate the product and to
determine the ages of the top cover
and surface core assembly.
To Next Page
Loading...
