baxter Hillrom pro+ - Intended Use; Introduction

pro+ Surface Instruction for Use (209196 REV 8) 1
Intended Use
INTENDED USE
The Hillrom pro+ surface is intended for patient support and for the
prevention and/or treatment of pressure injuries.
NOTE:
The pro+ surface is intended for use in healthcare environments and is
capable of being used with a broad patient population as determined
appropriate by the caregiver or institution. The surface supports patients
weighing between 70 lb (32 kg) and 500 lb (227 kg).
INTRODUCTION
The pro+ surface (mattress) with Advanced Microclimate Technology
(AMT) uses a non-powered system of intake and output valves to provide
weight-based pressure redistribution whenever a patient moves or is
repositioned.
This manual contains information necessary for normal operation of the
pro+ surface. Before you operate the surface, make sure you read and
understand in detail the contents of this manual. It is important that you
read and strictly obey the aspects of safety contained in this manual.
The pro+ surface can be used on the bed frames shown below. To
determine if the pro+ surface can be used on a hospital bed not listed,
contact Baxter.
• Hillrom Centrella Smart+ Bed (36" (91 cm) and 40" (102 cm)
wide)
• Hillrom VersaCare Bed
• Hillrom Advanta 2 Bed
• Hillrom CareAssist Bed
• Hillrom 900 Bed, models LI900B2 (with split rails only) and
LI900B3 (with split rails only)
WARNING:
Warning—It is the user’s responsibility to make sure the occupant is safe
if the surface is used on a bed frame not approved by Baxter. Failure to do
so could cause injury or equipment damage.
For use on a bed frame not approved by Baxter, evaluate the bed frame
with the pro+ surface installed to make sure it is safe for patient use.